Leasing schema

supply: 220 V, 1 Ph, 50 Hz
* Power based on the following conditions: Ambient temperature 20 ° С, water temperature 15 ° С до 55 ° С
** Associated with additional e-heater
*** The tube can be reduced by 177 мм to 160 мм

SPECIFICATIONS

• Steel tank with double layer vitrification
• Rust magnesium stick to ensure the sustainability of the tank
• Capacitor isolated out from the tank, protected from dirt and water gassing
• Thermal insulation polyurethane foam (PU) with high density
• Outer sheath of gray RAL 9006 plastic material
• Acoustically insulated plastic cover on top
• High efficiency compressor with R134a refrigerant
• Protection for high and low gas pressure
• The device has an additional backup electric heater (with integrated thermal cut with protection set at 90 ° C), ensuring constant hot water even in extreme cold winters
• ON-OFF contact to start the unit by an external switch. • Weekly disinfection cycle. • Ability to control recirculation of hot sanitary water or to integrate solar water (presence of a special temperature probe, switch the flow of inflow and command an external pump)
• The conduit of entry / discharge of air can be reduced by 177 mm by 160-reducer membrane inserted in the end of the conduit

Highly thermodynamic domestic hot water to -10 ºС external heat exchanger
Thermodynamic boiler for hot water is one of the most economical systems to heat the water needed for the family household. Using free renewable energy air unit is highly efficient with low operating costs. Its efficiency can be up to 3-4 times higher than that of the conventional gas-fired boilers or electric heaters.
Compact design The device is designed specifically to provide hot water for domestic use. The extremely compact structure and elegant design are suitable to izstalira inside the room.
OFFERED MODELS To be suitable for different installation requirements, CALIDO  the unit is available in 3 models: CALIDO: Standard version, heat pump and electric heater CALIDO-S: With additional coil for use in combination with solar panels CALIDO-D: With two coils to simultaneously have three energy sources
MULTIPLE FUNCTIONS The special design of the outlet and inlet air makes the device suitable for different connection methods. In the various types of installation, the unit can operate as a heat pump, as well as ventilation for fresh air dryer or as a device for energy recovery.

• Standard version, heat pump and electric heater
• Rust magnesium stick to ensure the sustainability of the tank
• Thermal insulation polyurethane foam (PU) with high density
• Highly efficient refrigerant compressor R134a
• Protection for high and low gas pressure